Peugeot 308 Key Fob Problems and How to Fix Them
If your Peugeot key fob suddenly stopped working, it could be because of a dead battery in the coin-cell unit, water damage, receiver module issues, or a defective chip. These are all simple fixes that can get your car back to speed in no time!
The blade of the key can get worn out and lead to a malfunctioning car key. It is easy to fix if you visit your local Car Key Man Auto Locksmith and let them fit a new key blade for you.
Battery
The key fob in your Peugeot 308 may die or become weak enough to not send a powerful signal. This could cause the key fob to cease working and prevent you from opening and locking the doors or starting your engine. You'll need a replacement battery for the key fob in order to fix this.
You'll need to buy batteries for replacement from an auto parts shop or your local hardware store. Make sure that the battery is brand new and has not stored on the counter for too long. A new battery has greater capacity and can transmit a stronger signal your car.
After replacing the battery, try unlocking the doors and locking them using the key fob. If the doors don't open it's possible that the receiver module in the car is the cause. The local Peugeot dealer can reprogramme the receiver module.
It's possible that the chip inside your key fob is damaged. This could happen if drop your key fob on the ground or expose it to water. The rubber seals that protect the chip from moisture could wear down over time, particularly if the key fob is exposed to water for long periods of time like submerging it in the ocean at the beach. To prevent this from happening, it's essential to protect your key fob from moisture and never let it come into contact with water.
Water Damage
Don't let go of your key fob when it gets wet, no matter if you dropped in the pool or stumbled into a Puddle. While the key fob has rubber seals which should shield it from water, long-term exposure to water may cause damage to its electronic chip. Water is a good conductor and any water that is absorbed into the key fob will cause a series short circuits which eventually damage the electronic chip. After removing the batteries clean its contacts with isopropyl. Dry them completely before putting them back into.
A dead battery could be the reason that your Peugeot 308 won't start. Jumper cables can be a great method of restarting the engine in case you have an additional car. If the battery is causing the problem the battery will need to be replaced.
A poor receiver in the car can also prevent it from receiving the signal from the keyfob. It could be due to a issue with the antenna or wiring, or the key fob might be damaged. If you are using the latest key fob, it may need to be programmed to the vehicle. If you're unable to fix the issue on your own then contact an expert technician. peugeot partner van key fob trained technician will be able to find the issue quickly and resolve it in a timely manner.
Radio Interference
Interference can cause symptoms such as a key fob that is not recognized or has a restricted range. It could be radiated or conducted, with the former being caused by power supply cables and the speaker wiring being too close to electrical components. Generally speaking, rerouting cables or moving them further away from these components could solve the problem.
It's unlikely someone is listening to your key fob's signals in attempt to steal your car however it is possible that radio frequency interference has drowned out the signal. Fortunately, this is easy to fix.
If your key fobs that aren't being recognized, try using a new battery. Also, make sure that the battery is the right size and type. If the battery is not properly sized, it could damage the fob.
These devices could interfere with the key signal if they use the same radio frequency. It is advised to avoid having these devices attached to your key fob.
Pairing Issues
The remote keyless entry system that is used in automobiles has a receiver that receives radio frequencies from the key fob. You won't be able to start your car if this receiver is not functioning properly even if your key fob is functioning and can be reprogrammed. The issue can be caused by a variety of causes, including an inoperative coin battery or water damage. The receiver could also be malfunctioning due to an internal or software issue or damage to the key itself.
One of the most frequent reasons why your Peugeot 308 key fob isn't functioning is that the battery inside has failed. You can easily replace this with a new battery, however, it is essential to choose the right battery for your key fob. It is best to choose a battery that is the same size, voltage, and specification as the original.
Your Peugeot 308 keyfob may not function if it was paired with another vehicle. This could happen if you have given your key fob away to a friend or in the event that the key was used to unlock or start other vehicles. This can be resolved by reprogramming your key fob with an OBDII scan. This tool will ask for details about your car such as its VIN or engine type. It is important to enter the correct details.